Each of these patterns has its strengths, depending on how they are used. You can set the Blue Yeti according to four pick patterns: stereo, cardioid, omnidirectional, and bidirectional. At the front of the microphone, you can also adjust the volume of the headphones. The Blue Yeti comes with a 3.5 mm headphone jack that lets you monitor your recording in real-time, with no latency delays. In short, gain allows you to control the sound before processing so that you can refine the tone of your sound.Įxpert Tip: If you encounter distortion or feedback when recording from a loud source, just lower the mic’s sensitivity through its gain control. However, the two are completely different ideas: Volume is the output level while the gain is the input level. People often get confused with gain and volume because they are used interchangeably by people. Since the Blue Yeti is a side-address mic, it must be in an upright position and the speaker perpendicular to it, so you can speak or sing to its sides. ![]() Once you have fixed the microphone’s position, tighten the set screws on the base. The Blue logo and headphone volume must be facing you for easy access. Place the microphone on a sturdy table or desk to keep it secure. This means that you have to configure it properly to pick up the acceptable amount of noise. ![]() ![]() As a condenser microphone, the Blue Yeti has a frequency response of 20Hz to 20kHz, which is sensitive enough to pick up even the faintest sound in the surroundings.
0 Comments
Leave a Reply. |